COMET CENTRAL

So I just got my new kick panels for my 62 comet sedan, and they do not fit. This is the part number from Macs C2DZ-6402344-5 for 60-65. This is the part number from Auto Krafters. C1DB-6402344-5 for 60-63. They both look the same but different part numbers. Thoughts?

poboyjo65 wrote:Not sure what you're asking. if you buy a new carpet set they usually come slightly larger & are trimmed during installation . AFAIK.

Basicly asking how to install this without screwing it up. Every thing I found calls for using the old carpet as a template.

Ok next question... The original carpet was garbage. How do I go about installing without having the old on as a template.

thank you.

Ok so the original carpet in my 62 resembled anything but. I have a new carpet to install. my main question is the placement of the gas pedal. Does it sit on top of the carpet, or do I need to make a slit?

I am getting ready to replace the carpet in my 62, and I need to replace the vinyl pieces under the doors. Any thoughts?

Remind me, what year Comet? The old Load-O-Matic distributors (mid '64 back) were matched to the carb, if there is a mismatch between carb and the distributor will not advance properly, they were a vacuum only distributor, not sure of the fix (can't remember) but can try and look up the solution if...

ok so I swapped out the points for an ignitor package.....new plugs, wires, had the carb rebuilt, but they screwed that up by loosing a part of the linkage......has a new tank from previous owner. just rechecked the timing after installing the ignitor ignition module. still hesitates on acceleration...

I put the bondo on first,really don't think it matters as long as you scuff it good with at least 80 grit. If it is going to take you a few months to get it done spray the epoxy on the car, then you won't have to worry about it rusting. Matt STOP....... don't use bondo it will suck moisture out of ...

I just got back from a shop for a quote for floor pans. Quoted me around $3400.saying it would take a week...And that's just labor, I got to buy the pans.....Anyone replace theirs in a 62, and how long did it take the shop? As for a shop, Floor pans are floor pans. I would think 40 hrs for a shop t...

well i got it all back together and the new switch isnt working....rt signal works but no indicator...left does not work yet the indicator is steady.... not blinking....replaced bulb....i have parking lights......any thoughts?

bmmaurer wrote:Here Ya go...

where did you find this?

bmmaurer wrote:Here Ya go...

that helps..looks a bit different
thanx

poboyjo65 wrote:

captian_napalm wrote:Ok next dumb question.....I cant remember where the spring went....damn crs

spring? damn crs big one?

small one. I know the big one goes under the horn ring

Ok next dumb question.....I cant remember where the spring went....damn crs