Cowl cover pannel

[StPro]

Autokrafters
https://www.autokrafters.com/p-22336-co ... alcon.aspx

[StPro]

I ordered the cowl last week it showed up Friday. It is a nice looking piece Smooth and clean with all the right dents and notches. It should be a easy weld in piece. I did notice one flaw in the piece there is a tear in the sheet metal on the drivers side in the corner under the fender. Nothing a welder wont fix and will never be visible under the fender. I was going to post a pic but photo bucket started blocking all my post in the preview mode so I deleted it

[Jims65cyclone]

Just use the "Upload Attachment" tab below the Post a Reply window and forget about PB. The only catch is the pic has to be fairly small, like no bigger than 256k, I think. You can resize it using Paint if you're using Windows.
Jim

[StPro]

This is the small tear in the corner I mentioned.