COMET CENTRAL

Looking for a 4 speed shifter boot for my '66 comet with center console. I have looked for 2 days with no luck, I bought one that I thought would fit but no luck. Also I have a hurst shifter so I need the square hole.

Poboy, I think that reflection would look good if was permanent!

Thanks, it is a 445 4 speed and just got done with the engine 3 months ago and it kicks ass!

I know it's a old post but that comet sold on BAT several years ago. I think 27k

i hear folks are getting good power from the trick flow heads but dont forget to address the rockerarm pads. you have to mill .250 off of the rocker pads to get the geometry right on tfs heads.for some reason trick flow rocker stand pads are .250 taller than stock.i dont know why they did that,but ...

https://i.postimg.cc/G8gH8MbD/DSC00116.jpg This is how I have the pump mounted till I get the proper brackets. It has the 2 bolts coming off of the head then there is a turnbuckle?? from a water pump bolt to 1 of the 2 bolts from the head to stabilize it. It's holding pretty good but I wouldn't tru...

I had a new pressure hose made up 9" longer and 3 feet on non pressure hose and a power steering cooler mounted in front of the radiator. I drove the car for the first time in 2 years a little bit and the steering is very nice, it felt like I was driving in my wife's car. At first I wasn't even thin...

Got the engine in and got the pump hooked up with the hoses.I will have to get longer hoses as both of them are right next to the headers. But I did have the engine running and the steering worked fine. I haven't been driving yet so we will see. This is the only way I could figure to set the pump up...

Well its been a while but this is how far I am. I pulled my motor for a rebuild so that gave me plenty of room to put the Borgeson unit in. When I first called the company to ask about the install they told me that I would have to cut 21/2" off of my steering column. Wrong. I'm about a inch or so fr...

I cut the steering shaft at the manual steering box and the shaft slid out from inside the car with the steering wheel still attached. How do I get the top piece of the wheel off, the piece that you push to honk the horn? I tried pushing down on it and turning counter clockwise but when I push down ...

Thanks for the printout. I just received the Borgenson pump today with the other parts coming. Not going to start for a week or so till the weather warms up, I live in Pa.

I think I will make the switch and will let you know how it turns out.

Thanks. Does the steering shaft just slide out then? If it does is it from the bottom you pull it out or the top or either? Thanks