COMET CENTRAL

I hope this works for posting a pc
https://i.postimg.cc/bv779YfJ/torino-gt-1970.jpg

Jims65cyclone wrote:Slacker!!

Jim

I do have other things I have accomplished this year. OH you weren't talking to Me

I would like to say the project is looking great. I would have thought about spinning the car around. I would have thought twice and chickened out until I had a ton of help

I saw it. I did enjoy it. It added a little more perspective on the 60's

Guess it has been a few days since I posted :roll: I have been busy mounting casters on the bottom of the Comet so it will not drag the floor pans out going down the highway :roll: I thought they were to keep passengers from dragging there feet when you are going to blow the doors off the local ric...

I bought some just for testing. I found it good for soldering not welding. The last stuff I bought was Muggy weld. I used it repair the metal grill parts on my 70 Torino. Low heat is the key. Enough heat to make the rod melt on the base metal. Any more heat and the and things start to oxidize and wo...

That was a concern. With out the two cars setting next to each other you could not tell the floor angle or the height of the fire wall.
Thank You

Does anyone own a 65 mustang? I would like a couple of dimensions off the cowl. I am thinking of replacing my firewall, rear aprons, lower cowl, cowl side panel and part of the cowl with mustang sheet metal. By replacing these parts I can move the engine back in the engine bay and have all new sheet...

Now that Motortrend is up and running have you noticed the drag Comet in the trailer. If you noticed the Comet do you remember what the other car was without watching again.

I just sent My Ford 351C Ready-To-Run Pro-Billet Distributor in for repair $63-128
https://bangshift.com/general-news/spon ... vs-a-fake/
See link above info on fake

That hurts just to look at it.

The holes you drilled in the metering plate can be returned to the original size if you have the patients and skill to do so. The basic concept is to drill out the hole to 1/8" dia. countersink both sides of the plate (DO NOT CUT DEEPER THAN HALF THE PLATE THICKNESS ON EACH SIDE). Cut off a piece of...

I had to weld on a display rack last night . I have been welding since I was 16 and when you are out of practice it shows

The worst part of having extra or new parts filed away is having to go and buy another because you can’t find it because you cleaned last week.

Absolutely nothing! And its killing Me. I need spring.