67 Ford Fairlane at Leno's garage

All the Ford Sisters...Falcon, Mustang, Maverick & Fairlane, etc. Try and keep your post relevant for Comet users
Post Reply
Santa's Comet
Posts: 250
Joined: Wed Jul 31, 2013 2:48 pm

67 Ford Fairlane at Leno's garage

Post by Santa's Comet »

Most members have probably seen this u-tube but it's new to me.
The suspension on this Fairlane is wild.
I hope I can get the u-tube pasted. https://www.youtube.com/watch?v=UonisqLOnXo
Later Dave
Image

CALIFORNIA CALIENTE
Posts: 5933
Joined: Mon Feb 20, 2006 12:57 am
Location: Camarillo,California

Re: 67 Ford Fairlane at Leno's garage

Post by CALIFORNIA CALIENTE »

I had the pleasure of seeing this car,over,under,inside and out,it is BEAUTIFUL.I spent at least an hour talking with one of Steve's Fabricators,they will answer ANY question about their cars!! ROY.
Real Racecars have 3 pedals
Image

Santa's Comet
Posts: 250
Joined: Wed Jul 31, 2013 2:48 pm

Re: 67 Ford Fairlane at Leno's garage

Post by Santa's Comet »

Roy, I was hoping to see more pics on how they did the torsion bar in the trunk and front end!
What a great looking car! I liked how they went all ford parts. (except rear)
NP Dave
Image

CALIFORNIA CALIENTE
Posts: 5933
Joined: Mon Feb 20, 2006 12:57 am
Location: Camarillo,California

Re: 67 Ford Fairlane at Leno's garage

Post by CALIFORNIA CALIENTE »

While I was checking the car and talking to the builders,I forgot to ask about the torsion bars!! Very well done car,great guys!! ROY.
Real Racecars have 3 pedals
Image

lavron
Site Admin
Posts: 4710
Joined: Sat Nov 01, 2003 9:17 am
Location: Missouri, Ozarks
Contact:

Re: 67 Ford Fairlane at Leno's garage

Post by lavron »

That is one cool Fairlane.

See Ya,
Mike
Mike's build thread
viewtopic.php?f=9&t=13058
Image

Santa's Comet
Posts: 250
Joined: Wed Jul 31, 2013 2:48 pm

Re: 67 Ford Fairlane at Leno's garage

Post by Santa's Comet »

Some of the Comets on this forum could get away with that air brake!
That would get attention in stop and go traffic!!
NP Dave
Image

Post Reply