5.0 intake manifold breather?
5.0 intake manifold breather?
There's a hole in the back of the stock 5.0 mustang intake that I assume had something in it from the factory in the mustang, or whatever. Now that Ive got it, its just a hole. Should I plug it, put a breather in it, pcv...? Its about 1"-1 1/4" maybe, very center in the back. Thanks
- Boss/Cyclone
- Site Admin
- Posts: 2740
- Joined: Thu Oct 19, 2006 9:55 pm
- Location: South Central Michigan (Near Michigan International Speedway)
Re: 5.0 intake manifold breather?
It was a pcv, should be a wire mesh filter in the bottom of the hole. Can't remember where it the tube ran to, been a while since I had a foxbody Mustang.
1965 Mercury Cyclone former drag car, 1971 Boss 351 engine, 4 speed, ladder bars, etc. Now returned to a street car.
Larry
Larry
Re: 5.0 intake manifold breather?
That makes sense. I don't have the wire screen. You think I can just plug it and run the pcv in the valve cover? Or would it be better with the pcv there and breathers in the valve covers?
-
- Posts: 1870
- Joined: Wed Mar 12, 2014 10:37 pm
- Location: Santa Clara, Ca
Re: 5.0 intake manifold breather?
Simplest to just use the pcv and breather in the valve covers. Plug the hole with something.
Ron
Ron
Re: 5.0 intake manifold breather?
Thats kinda what I was thinking Ron. Thanks!! I like simple.
-
- Posts: 234
- Joined: Wed Jan 21, 2015 12:54 am
- Location: Vancouver, BC
Re: 5.0 intake manifold breather?
The pcv used to go from the rear hole to the vacuum fitting on the upper intake of the efi manifold
Re: 5.0 intake manifold breather?
Ahh, I see. Thanks!!
Re: 5.0 intake manifold breather?
Got the hole plugged! I hope anyway. Used one of those rubber expanding plugs. It would have been a lot easier to do before I installed the intake. I ended up kinda pounding it in with silicone all over it and putting more silicone around the lip. Even though it says right on it to NOT use silicone. I couldn't come up with another way to do it. If it comes shooting out when I fire up the engine I guess I'll come up with another plan.