new here

The Round Body, Finned Comets
Post Reply
prestoneger
Posts: 3
Joined: Mon Oct 27, 2014 3:52 pm

new here

Post by prestoneger »

hello there guys inm 19 go to an auto otive school recently picked up a 63 comet shell for 400 buck I need a drivers side floor pan full length and rear quarters both sides

User avatar
383MERC
Posts: 1176
Joined: Mon Sep 06, 2010 12:02 am
Location: Center Valley, PA

Re: new here

Post by 383MERC »

Hi, and welcome to the site. Where are you located? Is your car a hardtop or a sedan? Quarter panels are not available. I've seen patch panels on EBAY. I was lucky enough to find a full NOS passenger side quarter years ago, but can't get rid of it. I race a 63 and....well you just never know! haha Mark
1963 Comet S-22 Drag Car
1964 Fairlane 2 door sedan T-Bolt Clone
2007 Shelby GT
1989 LX 5.0 Convertible

prestoneger
Posts: 3
Joined: Mon Oct 27, 2014 3:52 pm

Re: new here

Post by prestoneger »

It is a hardtop sir and i'm located in hanover pa its near Gettysburg I really only need the very back bottom fin. but I know what you mean about never knowing thanks for any and all help in advance.

User avatar
Groover
Posts: 1796
Joined: Wed Jun 02, 2010 11:36 pm
Location: Indianapolis, IN

Re: new here

Post by Groover »

Welcome aboard. You'll find all the help you need right here in Cometland.... except for those quarters ;)
Image
1964 Comet Caliente Convertible
30,000 miles on our rebuild

All Comets start out as dreams...

User avatar
383MERC
Posts: 1176
Joined: Mon Sep 06, 2010 12:02 am
Location: Center Valley, PA

Re: new here

Post by 383MERC »

What exactly do you mean by the back bottom fin? Mark
1963 Comet S-22 Drag Car
1964 Fairlane 2 door sedan T-Bolt Clone
2007 Shelby GT
1989 LX 5.0 Convertible

CometGuy1961
Posts: 7
Joined: Fri Oct 17, 2014 12:32 pm

Re: new here

Post by CometGuy1961 »

Welcome and good luck on the rebuild... :D

Post Reply