ignition switch
-
- Posts: 47
- Joined: Tue Nov 29, 2022 9:48 am
ignition switch
Trying to get this project going. New switch but old ignition solenoid. I will start and run but will not turn off at the switch. I tried a second new switch I had on hand. Same thing. Acording to factory electrical manual I have the wires going correctly to switch.
-
- Posts: 47
- Joined: Tue Nov 29, 2022 9:48 am
Re: ignition switch
I figured it out. That little wiring harness that plugs into the back of ign. switch was NEW and BAD!!! Go figure!
- Boss/Cyclone
- Site Admin
- Posts: 2745
- Joined: Thu Oct 19, 2006 9:55 pm
- Location: South Central Michigan (Near Michigan International Speedway)
Re: ignition switch
I feel like there have been a lot of defective new parts lately. Glad you figured it out.
1965 Mercury Cyclone former drag car, 1971 Boss 351 engine, 4 speed, ladder bars, etc. Now returned to a street car.
Larry
Larry
- Joe Travers
- Posts: 2465
- Joined: Mon Sep 21, 2020 6:23 pm
- Location: Louisiana
Re: ignition switch
Cool
I was tempted to post a relay replacement. Used to throw $$ @ problems but times have changed, unfortunately
As Boss posted, nothing is made as well as it was. That relay may last another 50 years.
Joe
I was tempted to post a relay replacement. Used to throw $$ @ problems but times have changed, unfortunately
As Boss posted, nothing is made as well as it was. That relay may last another 50 years.
Joe