65 cyclone grille emblem
Re: 65 cyclone grille emblem
I have a couple of the Caliente grille emblems. I am thinking of chopping one down to clone the Cyclone.
-
- Posts: 9
- Joined: Tue Nov 07, 2023 7:15 am
- Location: San Diego, CA
- Contact:
Re: 65 cyclone grille emblem
Hi all,
I know this is a really old thread but does anybody know how to attach Mr Mercury? It has the pen to guide it and then it has what looks like a tube that goes through. The old one looked like pop rivet but not sure how I would get a popper to come on that. I was thinking about like a nut and a screw maybe but wondered if there's some kind of trick?
I know this is a really old thread but does anybody know how to attach Mr Mercury? It has the pen to guide it and then it has what looks like a tube that goes through. The old one looked like pop rivet but not sure how I would get a popper to come on that. I was thinking about like a nut and a screw maybe but wondered if there's some kind of trick?
Re: 65 cyclone grille emblem
I have used this product many times, if you prep the two surfaces the tape is almost permanent. OEM uses it on emblems and trim.
https://www.3m.com/3M/en_US/p/d/b40069527/
Jim
https://www.3m.com/3M/en_US/p/d/b40069527/
Jim
Re: 65 cyclone grille emblem
Jim has it right.
I have a good friend with a '62 Galaxie that has big heavy trim, a lot of it held on with this stuff.
I have a good friend with a '62 Galaxie that has big heavy trim, a lot of it held on with this stuff.